-17-
state, then continue measurement.
In the MR state, need to press MEM key to exit the MR state, then
continue to measurement.
In setting Alarm Critical Value state, need to press the ON/OFF key
or press the AL key for 3 seconds, exit Alarm Critical Value state,
then continue to measurement.
In the current test mode, press Ω key to switch to resistance test
mode.
4．Current Measurement
After the booting auto-inspection is completed, the Meter auto-
matically enter the resistance measurement mode. Upon showing
"OL Ω", press A key, and the Meter enter the current measurement
mode, showing "AC 0.00mA", see Figure 7. At this point, press the
trigger and open the jaws, clamp the target wire, reading to get the
current value.
It shows "OL A‖, indicating
that the measured current
value exceeded the upper
limit of Meter, see Figure 8.
Flashing display symbols , go with intermittent "beep
--beep--beep--" sound, indicating the measured current exceeds
the current of Alarm Critical Value.
In the HOLD state, need to press HOLD key to exit the HOLD
state, then continue measurement.
In the MR state, need to press MEM key to exit the MR state, then
continue to measurement.
To Next Page
Loading...
