eTIGER Secual Box V2 - Control by Phone Call

23 / 36
Control by phone call
This function applies only if you are using the Secual Box with a SIM
card.
This function enables you to control your alarm system by phone call. This can especially
be helpful if you are located in an area without Wi-Fi or 3G/4G coverage.
How it works
1. Call the phone number of the SIM card in the control panel.
2. The control panel picks up: type your 4-digit passcode, followed by "#" (Default
passcode: 1234).
3. A voice prompt confirms if your code is correct.
4. On your phone, dial the code corresponding to the command:
Table 1
Dial
Command
1
Arms the system
0
- Disarms the system and turns the siren off
- Stops monitoring without hanging up
*
Audio monitoring
6
Turns the siren off
9
Turns the siren on
#
Disarms the system, turns the siren off and ends the phone call
If your alarm is triggered
If the alarm is triggered, your control panel immediately starts to inform you:
At home
- The built-in siren starts ringing out.
- If you have connected additional sirens, they start ringing out too.
On your smartphone(if your alarm is connected to your Wi-Fi network)
- You receive a push notification in the Secual Box app (you must havee an Internet
access on your smartphone).
On your smartphone (with a SIM card in the control panel)
- The control panel sends an SMS notification to every SMS number saved.
- The control panel calls every Phone number saved. If you take that call, you can
decide to stop the siren, disarm the system or other functions as listed below, by
dialing the corresponding code in Table1.