EN 19
Symptom Possible cause Solution
Symbol L appears in the
displays.
Lock function activated. Touch simultaneously for a
minimum of three seconds
the rear left cooking zone plus
(+) key and the minus (-) key
until you hear a audio signal.
Eror code Er03 in the display.
You have pressed two or more
keys at the same time.
Do not operate more than one
key at the same time.
The control panel is dirty or
has water lying on it.
Clean the control panel.
Error code U400 and/or
continuous beep.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Let your connection be
changed.
Not able to switch on the
centre or right side cooking
zones. You hear an audio
sound.
Maximum setting on 2 phase
limitation is reached.
Reduce settings; consult the
power managament table.
Other error codes.
Defective generator. Contact the service
department.
TROUBLESHOOTING
To Next Page
Loading...
