9
MAINTENANCE
Generator maintenance consists of keeping the
unit clean and dry. Be sure to store the unit in a
clean and dry environment, where it will not be
exposed to excessive dust, dirt, moisture or any
corrosive vapors. Cooling slots should always be
clean and free from clogs.
Note: Do not use a garden hose to clean the
generator. Water can enter the fuel and intake
system and cause problems. In addition, if water
and dirt buildup on the generators internal
windings, the resistance of these windings will
decrease.
• To clean the generator, use a damp cloth
to wipe the exterior surfaces.
• Use a soft bristle brush to loosen caked on
dirt of oil.
• Use a vacuum cleaner to pick up loose dirt
and debris.
• Compressed air (not to exceed 25 psi) may
be used to blow away dirt.
SPARK P LUG
• Remove the spark plug
• Remove the carbon deposits
• Check for discoloration. Standard is tan in
color.
• Check spark plug gap
Make certain the spark plug gap is
0.7 -0.8mm (0.028 - 0.031 in.).
AIR FILTER
• Unscrew the bolt from the air cleaner
cover, and remove the air cleaner cover.
• Check the air cleaner element to be sure
they are clean and in good condition.
• If the air filter is dirty, remove and clean
the element.
• Wash in solvent
• Squeeze
• Soak oil
• Squeeze dry
• Reinstall the air cleaner element and
secure the cover by setting the cover
spring.
RECEPTACLES
This generator is equipped with the following
Receptacles
NEMA 5-20R: 125 V o l t , 2 0 A m p G F C I D u p l e x
Receptacle
L5-30R: 120Volt, 30Amp Twist Lock Receptacle
To Next Page
Loading...
