Etrel INCH LITE - First Power Up

12 | 18
Etrel Inch Lite | User Manual
|
3 OPERATION AND CHARGING PROCEDURE
FIRST POWER UP
Before starting the station, it is absolutely necessary to read this
manual and the technical specification of the device.
When the charging station is power up for the first time it can take
several minutes for station to get ready to start using it to charge EV.
Charging station is powered up automatically when it is connected to
the electricity. In the table below, all possible events that can occur at
the power up of the station are listed with the procedure what to do in
case something is wrong.
STATUS LIGHT
NORMAL
OPERATION
PROBLEM
SOLUTION
Fast blinking
green light
Charging
station’s backup
batteries are
charging. At the
first power, up it
can take up to 10
min. If backup
battery is full
green light will
blink slowly.
If the light is
blinking fast
more than 10
min there might
be a problem
with the backup
battery.
Inform the
support about
the status of the
charging station.
Slowly blinking
green light
Heating system
is trying to heat
the electronics
before it is
turned ON.
If the green light
is blinking slowly
for more than 10
minutes, there
might be a
problem with the
hardware.
Support should
be called.
Steady glowing
green light
Charging station
is ready to be
used.
/
/
No lights
/
If charging
station is not
responding after
it is powered up,
something might
be wrong with
connection.
Check the
protection
elements if
either RCD or
overcurrent
protection has
been tripped.
Activate the