12 | Maintenance
ROUTINE MAINTENANCE
Routine maintenance should be conducted prior to each use of the turntable.
Remove foreign objects from between turntable top and
floor flange—Visually inspect the turntable prior to use, and look for foreign
objects in the gap between the turntable top and the floor flange. Remove the
objects, if possible.
Check for excessive rotation—Attempt to rotate the turntable top by hand.
Excessive rotation may indicate a loose drive component.
Listen for excessive noise—Listen for excessive or unusual noise during
turntable operation.
6-MONTH SERVICE
Lubricate the casters—Lubricate the casters with good quality bearing
grease.
Inspect the ground brush for contaminates—Vacuum the ground brush to
remove unwanted debris. If required, add a small amount of conductive
lubricant to the brush interface.
Inspect the ground brush for wear—Visually inspect the ground brush for
wear; if necessary, replace the ground brush.
12-MONTH SERVICE
Lubricate the main bearing race—Lubricate the main bearing race with a
grease gun containing good quality bearing grease. The grease fittings are
located inside the race, 90 degrees apart, beneath the top. Three discharges
from the grease gun in each fitting are adequate.
Lubricate the chain and sprocket of the chain drive—Apply good quality
grease to the chain and sprocket.
To Next Page
Loading...