22 | Assembly and Installation
3/8-in hand drill Syringe to apply conductive grease
9/32 drill bit Grease gun
#2 Phillips screw bit Vacuum
#3 Phillips screw bit
1.2-in hammer drill
Assembly Instructions
Do not discard any packing material until the turntable is fully installed
and operational.
When working around the turntable, do not step on the
fiber optic connectors located on the motor base.
1. Uncrate all parts and check for shipping damage. Create a clear area to
safely assemble the turntable unit.
2. Verify that that fiber optic cable is long enough to reach from the
turntable to the control room.
3. If the turntable is to be installed in a pit, measure the depth and inside
diameter of the depth. Compare the measurements with the drawings
located in the back pocket of this manual.
The inner diameter of the pit should be as follows:
1.0-meter turntable—49.00 in (+/-0.25 in)
1.2-meter turntable—49.00 in (+/-0.25 in)
1.5-meter turntable—60.00 in (+/-0.25 in)
2.0-meter turntable—79.75 in (+/-0.25 in)
4. Remove the bolts that attach the top onto the turntable drive assembly;
these are the six flat-head bolts closest to center of the turntable top.
5. Remove the turntable top and place it in a safe location.
Only qualified personnel should use a forklift or other lifting
machinery.
To Next Page
Loading...