8 | Introduction
EMCenter Modular RF Platform
The ETS-Lindgren EMCenter™ Modular RF Platform (with EMControl™ Positioner
Controller Plug-In Card) may be used to control the Model 2188 Turntable. For
information on connecting and using the EMCenter, see the EMCenter Modular RF
Platform User Manual, available for download at ets-lindgren.com.
The EMCenter replaces the 2090 Controller, which has been discontinued. The basic
controller configuration is an EMCenter with an EMControl card. This assembly is
ETS part number 125241.
Check ets-lindgren.com or contact ETS-Lindgren to ensure that your EMCenter, the
EMControl card, the backplane, and display all have the current firmware versions.
EMCenter: V5.21 (or later)
EMControl (7006-001) Card: V2.5.6 (or later)
Backplane: V2.3.0 (or later)
Display: V1.4.10 (or later)
The EMCenter is also expandable with a variety of additional options available.
Please contact ETS-Lindgren with any questions.
Note: If you are unfamiliar with the operation of the EMCenter, see the
manual, available for download from
ets-lindgren.com.
The EMCenter replaces the 2090 Controller, which has been discontinued.
The 2090 requires firmware revision V 3.21 or higher. It is available for
download at ets-lindgren.com and requires the program Flash Upgrade
Wizard V 4.0 (also available at ets-lindgren.com).
Optional Items
INFRARED REMOTE CONTROLLER
The Model 2188 is infrared compatible, and can be used with a universal remote
control programmed to a specific protocol, such as the ETS-Lindgren Infrared
Remote Controller (IR remote).
To Next Page
Loading...