Legend 548 Assembly and User Manual - 21
30068-02A
Put the rear panel in place. Secure the pan-
el with (8) #10x1/2” screws from the back
side.
Slip the rear cross member into the cradles on
each pedestal and secure with (4) #10x1/2”
Phillips sheet metal screws on each end.
The rear angle cover attaches between the
rear panel and rear cross member with (16)
#10x1/2” screws along the angled fl anges.
Note: To avoid stripping sheet metal screws,
use this simple technique: Using a hand
screwdriver, slowly turn the screw counter-
clockwise until it clicks in place. Then turn
it clockwise until hand tight. Do not over-
tighten.
ANGLE COVER
REAR CROSS MEMBER
REAR PANEL
To Next Page
Loading...
