Name: Eubank EAA1036
Brand: Eubank
Rating: 5 (1 reviews)

Questions and Answers:

V
Vanessa KellyJul 25, 2025
Why does my Eubank Air Conditioner keep blowing fuses or tripping the circuit breaker?
- N
  Nicole ClarkJul 25, 2025
  If your Eubank Air Conditioner blows fuses or trips the circuit breaker, it could be due to several reasons. First, the circuit might have inadequate ampacity, in which case you should refer to Chapter 2 for electrical requirements and correct it. Second, there may be a short, loose, or improper connection in the field wiring, so inspect the wiring for any errors. Third, there might be an internal short circuit or loose connections within the unit itself; check the unit's wiring, consult the wiring and schematic diagrams, and test components, especially the compressor, for shorts. Lastly, excessively high or low supply voltage or phase loss could be the culprit; refer to the compressor troubleshooting section for voltage range limitations.
D
Daniel SpearsJul 30, 2025
Why is my Eubank Air Conditioner running constantly but not cooling enough?
- K
  Kenneth FrankJul 30, 2025
  If your Eubank Air Conditioner runs for extended periods or continuously but doesn't cool sufficiently, it could be due to a few reasons. Start by checking the air filters for dirt and ensure proper airflow by inspecting the blower's operation and removing any airflow restrictions. Additionally, low refrigerant levels could be the cause, so check for proper charge and possible refrigerant leaks. Another potential issue is a component failure, so check internal components, especially the compressor, for proper operation. Finally, the unit might be undersized for the job, and the solution is to add additional units for greater cooling capacity.
M
Mr. Larry ReidAug 9, 2025
Why is there water on the floor near my Eubank EAA1036 Air Conditioner?
- J
  Jennifer SotoAug 9, 2025
  If you find water on the floor near your Eubank Air Conditioner, there are a few possible reasons. First, there might be an obstruction in the condensate line, so check for any clogs or restrictions. Second, the condensate pan might have an obstruction or leak, so inspect the pan for any issues. Lastly, the unit might not be level, so ensure it is properly leveled.