EUFAB 16643 - Attempting to Start; Removing the Power Pack; Use as a 12 V Voltage Supply; Compressor

12
6.3.2 Attempting to start
6.3.3 Removing the power pack
6.4 Use as a 12 V voltage supply
6.5 Compressor
6.5.1 Filling a tyre using the car valve (Schrader valve)
Start the motor. Do not operate the starter for longer than 6 seconds. The battery of the power pack is not designed for longer
starting attempts. Pause for at least 5 minutes between two starting attempts. If the motor does not start after a number of
attempts, abort the process and investigate the cause of the defect.
First disconnect the black (-) pole calliper, coil the cable and attach the pole calliper to the designated holder. Then disconnect
the red (+) pole calliper, coil the cable and attach the pole calliper to the designated holder. Always maintain this sequence.
Recharge the power pack.
The Power Pack can be used as a 12 V direct current source for many devices that can be operated with 12 V direct current and a
12 V motor vehicle charging cable. Plug the motor vehicle charging cable of the device you wish to operate into one of the 12 V
outlet (Position 12 in the overview). The device you wish to operate should not require a current greater than 10 A.
In order to be able to work with the compressor, rst remove the air hose from the storage compartment (Position 11 in the
overview).
Open the lock on the valve
connection
Figure 7 Figure 8 Figure 9 Figure 10
Place the valve connection on
the valve
Lock the valve connection You can now ll the tyres using
the compressor
To ll, switch the compressor on using the switch (Position 10 in the overview).
The manometer (Position 9 in the overview) is used to give a rough approximation of the air pressure. When the desired air
pressure is reached, switch the compressor o. Remove the valve connection in reverse order (Figures 10 – 7).
After lling a tyre, check the tyre pressure again using a separate air pressure tester (e.g. at a lling station, vehicle workshop).
When lling, always pay attention to the correct air pressure (consult the operating instructions of your
vehicle for information). The compressor is able to supply of pressure of up to a maximum of 18 bar. If the
pressure is too high, there is a risk of explosion and injury.
Never allow the compressor to operate for longer than 10 minutes without a pause, otherwise there is
a risk of overheating. Switch the compressor o after 10 minutes of use and allow it to cool down for at
least 10 minutes before starting it up again. Never leave the compressor to operate unattended.