06
Operation & Installation
UNPACKING YOUR ICE MAKER
BEFORE FIRST USE
Remove the exterior and interior packaging. Check that the ice basket and ice scoop are included. If any
parts are missing, please contact our customer service.
Clean the interior with lukewarm water and a soft cloth. Remove the ice basket and clean it.
Find a place for your ice maker that is protected from direct sunlight and other sources of heat (ie., stove,
furnace, radiator). Place the ice maker on a level surface. Make sure that there is at least 6 inches of space
between the back and sides of your ice maker and the wall. Allow one hour for the refrigerant fluid to
settle before plugging in the ice maker.
The appliance must be positioned in such a way that the plug is accessible.
Unpack the appliance and check to make sure that all the accessories including ice basket and ice scoop
etc. are complete. Please contact our client service department if some accessories are missing.
Please ensure the ice maker is level and on a stable table or platform to avoid malfunction.
The incline angle of the ice maker cabinet should not exceed 45° during transportation or use. Never turn
the ice maker upside down. Doing so could cause the compressor or refrigerating
system to operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice
maker is moved or transported. Before using the ice maker for the first time, please wait for 2 hours after
the unit has been levelled and positioned in the proper place.
The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources
such as ovens, heaters and corrosive gases. Leave a 6-inch [15cm] space on all sides of the ice maker for
proper ventilation.
Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water
reservoir with water of room temperature or lower.
Do not use the appliance at a very cold environment [lower than 41°F/5°℃].
Clean the appliance by following the operation of "CLEANING AND MAINTENANCE" before operating.
To Next Page
Loading...
