07
Operation & Installation
Note: Please make the ice maker rests for 30 minutes before plugging it in if it has
been moved.
Note: Do not fil above the MAX water level mark.
USING YOUR ICE MAKER
Ensure that the drain plug at the bottom of water reservoir is closed well.
Pug the ice maker into the wall outlet the" "indicator blinks.
Open the top lid and remove the ice basket.
WARNING: Fill the water reservoir with potable water only.
Replace the ice basket and close the top lid.
Press the "ON/OFF” key and the '' ''indicator lights solidly.
The ice-making cycle will last approximately 20-30 minutes, depending on the ambient temperature and
water temperature.
The ice-making assembly is equipped inside of appliance, and the ice-making assembly will keep
producing ice when water is being pumped into it. When the ice forms in the ice-making assembly, the ice
cubes will be transferred into the ice tray and then the ice cubes will drop into the ice basket. And the
above action will be repeated until the ice basket is full.
The " " indicator will light up when the ice basket is full and then the ice maker will stop the
ice-making cycle automatically. Open the front lid and gently remove the ice from the ice basket with the
ice scoop. And then replace the ice basket and close the front lid, then the ice maker will restart its
ice-making function automatically. If the ice is not removed, after about 8 hours, the appliance will
automatically work again, alternatively, you can press "ON/OFF" key to restart the appliance.
The " " indicator will flash when the water reservoir is lack of water.
(a)If the appliance is connected with external water source by the 1/4PE tube shown in the section of
“CLEANING AND MAINTENANCE” (see Fig.1), the water reservoir will be refilled with water automati-
cally and the appliance will restart the ice-making cycle; alternatively, the user can remove the ice basket
and refill the water reservoir with water to "MAX" mark manually, and then the appliance will restart the
ice-making cycle automatically. Please remember to close the front lid after refilling water manually
avoid overflow.
(b)If the appliance is not connected with external water source, firstly remove the ice basket and then
manually fill the water reservoir with water. After the water reservoir is refilled with water, please close
the front lid, and then the appliance will restart the ice-making cycle automatically.
When you have got your desired amount of ice, stop the ice-making cycle by pressing the "ON/ OFF" key
and unplug the unit from the wall outlet.
Open the front lid and transfer the ice to a freezer.
Allow the ice maker to reach room temperature.
Suggest replacing the water every week. Please empty the water reservoir if the ice maker has not been
used for a long time.
The ice maker can be connected with external water source by the 1/4PE tube shown in the section of
"CLEANING AND MAINTENANCE" if you want to add the function of refilling water automatically.
To Next Page
Loading...
