Eumig Automatic P8 - Page 10

FT
Fig. $
Set the speed control A (Fig. 8) at its middle position.
Switch on the metor and proiectien lamp by means
of switch B.
Switch C operates the forward-reverse mechanism.
There is more about fhis on Page 14 "Reverse proiee-
ton”.
Your P B AUTOMATIC has a sperially developped
illumination system working on the law voltage prin-
ciple which guarantees high image brillianey and
maximum lamp life.
The projection lamp used is a 12 volt lamp with a 4-
pin bayonet tap. The average life of the lamp is
stated by the manufacturers ta be 25 hours.