Eumig Automatic P8 - Page 11

To replace the lamp, open the lamp house as shown in Fig. 7, turn the lamp
slightly, and pull it out. CAUTION: The lamp will be hof after projiection!
Insert the new lamp by pressing down slightly and turning in a clockwise diree-
tion. Replace the lid of fhe lamp house (Fig. B). It is not necessary to centre Hhe
projection lamp, as these special lamps are pre-centred, that is, the position of
the light point in relation to the cap has already been set with great accuracy
by Hhe makers.
The two serew feet D (Fig. é) are for tiling the projeetor.
In order to comply wifh regulations in various countries regarding the earthing
of electrical appliances, the P 8 AUTOMATIC is provided with an earth sodel
(Page 5, Fig. 3.
Fig. 7
Fig. B