If the
projector
is
very
cold, let it run
for
a
few
minutes
with
the
projection
lamp on
to warm it up
be
for
e loading it. Should the
motor
stop
for
some reason, such as
a momentary
power
failure, move the function
switch
to the
"STOP"
(off) position,
then
back
to the desired operating mode.
Slow-motion and still projection
t,.,
lSD/SEC.
If
you wish to
show
a given sequence
of
scenes in
slow
motion, move the slow-motion switch to the desired
slow-
motion speed -
12,
9,
6
or
3 fps (frames
per
second) -
or
to 0
for
still projection during
either
forward
or
reverse
projection.
To
make it easier
for
you to locate the
switch
position
for
the normal projection speed
of
18
fps, it is marked by a
green
indicator
lamp during projection.
Fast rewind through film channel
As soon
as
the leader attached to the tail end
of
the film moves into the picture, and
before the film comes
off
the feed reel:
Move
the function
switch
past the
"STOP"
(off) and reverse with lamp
positions
to
the fast rewind (instant replay) position
:0 .
The lens gate
swings
up, the projection lamp goes out, and the film rewinds rapidly
through the film channel.
Direct reel-to-reel rewind
Of
course the film can also be rewound onto
the feed reel externally, from reel to reel. This is
done by moving the function switch to the fast
rewind (instant replay) position
0'
Instant replay
If you
want
to
show
a given sequence
of
scenes once
more, you can
interrupt
the
fast
rewind at any time by
moving the function
switch
clockwise
to the
forward
with
lamp position
O.
7
To Next Page
Loading...
