COLOR GRADING MEDIA CONTROLLER
USER GUIDE
INSTALLATION AND SETUP
15
Chapter 2: Installation and Setup
Euphonix is dedicated to making your MC Color experience enjoyable and trouble-
free so we will periodically update the following software and documentation:
• EuControl: This software runs your MC Color and communicates to your audio/video
application. Always download the new version if prompted to do so after launching
EuControl.
• MC Color User Guide (PDF): This is the complete user guide for your MC Color.
Before proceeding, download the latest versions from:www.euphonix.com/artist/support
Unpacking and Elevating MC Color
Unpack your MC Color, power supply, installation CD, Ethernet crossover cable,
and riser brackets.
MC Color can be elevated or angled using small foldout legs on the bottom of
the unit or elevated and angled by attaching the larger riser brackets. Since both
methods require turning MC Color over, it is easier to do this before attaching
any cables. Turn it over and place it on a soft surface.
Pull out all four of the small foldout legs to moderately elevate the unit; pull out
only the back two to angle the unit towards you. Pull out the metal clips from the
same area as the legs and move them until they snap into the legs (Figure 2-1 left).
Figure 2-1 Foldout leg with locking metal clip (left); riser bracket (right)
Two larger, detached riser brackets elevate and angle the unit more than the fold-
out legs. Use moderate force to snap them into the bottom panel (Figure 2-1 right).
Unpack the trackballs and place them in their trackball holders.
NOTE: To remove the riser brackets, see MC Color User Guide.
Foldout
leg
Riser
bracket
Locking
clip
To Next Page
Loading...
Need help?
General
