Eureka NER600 - Cleaning Tools; Main Brush Maintenance

22
DAILY MAINTENANCE AND
SERVICING
Cleaning tools
Cleaning tools
1. Cleaning tools are located
above the dustbin;
Cleaning brush
2. Cleaning brushes are used for
the following purposes:
The blade is used to cut of
hair from rolling brushes;
The hair brush is used to
brush off the cut hair .
Blade
Hair
brush
Rolling brush maintenance
Main brush maintenance (weekly cleaning recommended)
1. Turn over the main unit, and by
putting your hand at the upper
dent of the main brush cover,
press to remove the cover and
pull it out, then take out the
main brush brush from the red end
cover of the brush;
2. Clean the main brush cover
and main brush with a
cleaning brush or soft cloth;
3. When needed, pry out the red
end cover with hard objects, to
clean up hair or foreign matters
entangled in the end-cover
gap with a cleaning tool or soft
cloth;
4. Clean the main brush with
water and dry it;
End
cover
5. After completion of the
cleaning, push back the end
cover into the main brush
body;
6. Insert the main brush body
inthe main brush chamber in
the indicated direction;
7. Push the main brush cover to
fasten to the machine.