MT70InstallationandInstructionsofuse
Disassembling the door (continued)
3. Loose the Embedding stirp;
Clean the sheets with warm water or washing-up liquid and polish dry with a soft clean cloth.
Assembling the door
Reassemble the door by following the above procedures in Reverse order.
Changing the lamp
Danger of electric shock!
Before replacing the oven light bulb, take the following steps:
● Switch off the oven;
● Disconnect the oven from the mains supply;
● Protect the oven light bulb and the glass cap by laying a cloth on the bottom of the
oven.
Replacing the oven side lamp and cleaning the glass cap
1. To remove the glass cover, hold the lower end with one hand,
insert a flat sharp implement such as a table knife between the
glass and the frame and pop out the cover.
2. If necessary, replace the halogen bulb with a 25 watt, 230 V,
300 °C heat - resistant oven light bulb.
Tip
● Always use a cloth when handling a halogen bulb to avoid
depositing oils from your fingers on to the surface of the bulb.
3. Replace the glass cover.
To Next Page
Loading...
