MT70InstallationandInstructionsofuse
Cleaning Safety (Continued)
Catalytic Liners (removable) - enamel surface
The removable cover casing is coated with a dark gray catalytic enamel that can become coated with oil
and fat distributed by circulating air during convection heating. These deposits will burn off at oven
temperatures of 200 °C and higher, for example, when baking or roasting.
Higher temperatures will result in faster burning.The oven and accessories should be cleaned after each use.
Otherwise further baking and roasting will cause the deposits to bake on even harder and cleaning may
become difficult and in extreme cases impossible.
Remove all accessories from the oven.
● Set the oven to conventional function.
● Set the heat to 250 °C.
● Run the oven for approximately 1 hour. The length of time will depend on the degree of soiling.
It is a good idea to set the finish time for the process using the end time setting, in case you forget to switch
the oven off at the end.
Cleaning Catalytic Liners by hand
Make sure the oven is cool before cleaning.
The catalytic liners can be cleaned using a solution of hot water and washing-up liquid applied with a soft
nylon brush. Allow to dry in drainer or out in the sun. Due to the surface not being smooth do not attempt to
dry liners with a cloth as material fibres may remain on the surface of the liner.
Do not use abrasive cleaning agents, hard brushes, scouring pads or cloths, steel wool, knives or other
abrasive materials. DO NOT use oven sprays on catalytic enamel as the chemicals used in oven sprays will
damage catalytic enamel and render it ineffective.
If using oven sprays on the interior oven surfaces, the catalytic cover casing must first be removed from the
oven.
Disposal Instructions
Disposing of the packaging material
The material used to package this appliance is recyclable.
Dispose of the packaging materials in the appropriate container at your local waste disposal facility
Disposing of old appliances
WARNING: Before disposing of old appliances, make them inoperable so that they cannot be a source
of danger. Removal of doors is also advised.
To do this, disconnect the appliance from the mains supply and remove the mains lead.
To protect the environment, it is important that old appliances are disposed of in the correct manner.
The appliance must not be disposed of with household rubbish.
You can obtain information about collection dates and public refuse disposal sites from your local refuse
department or council.
To Next Page
Loading...
