MT70InstallationandInstructionsofuse
Installing the Oven
Electrical installation of this appliance must be performed only by a licensed electrician.
The oven must be installed according to the instructions supplied.
Remove the protective vinyl from the door after installation.
Safety instructions for the installer
Installation must guarantee protection against exposure to electrically live parts.
Under bench Installation (Figure 1)
Figure 2 shows the product dimensions of this oven and the housing must be constructed to fit the oven.
Minimum carcass dimensions are outlined in Figure 3 & 4 to house the oven. The front fascia of the oven rests
against the front edges of the carcass. The bottom filler panel, drawers and cupboards will meet up with the
front face of the oven door for a flush mounting (Figure 1). Note the cutout requirement at rear of carcass,
this is recommended for improved ventilation of oven to protect both the oven components and the
carcass in which the oven is housed. Alternatively an opening under the oven will ensure proper ventilation,
this opening should measure 400mm wide x 300mm deep.
To Next Page
Loading...
