Euromatic EUR-26SPLIT - Page 25

25
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Indoor unit test
• Does the ON / OFF button work properly?
• Do the HEATING, COOLING and FAN modes operate normally?
• Do the TIMER-ON and TIMER-OFF functions operate properly?
• Does each indicator light work properly?
• Do the flaps for air flow direction operate normally?
• Is the condensed water drained regularly?
Outdoor unit test
• Is there any abnormal noise or vibration during operation?
• Could the noise, airflow or condensed water drainage disturb the neighbours?
• Is there any coolant leakage?
NOTE: The electronic controller allows the compressor to start only three minutes
after voltage has reached the system.
Test run
Before using this appliance, please ensure you complete a test run to confirm that
the appliance is working correctly.
1. Turn on the power supply.
2. Press the ON / OFF button on the remote control to turn on the air conditioner.
3. Press the MODE button to switch to cooling mode. Set the lowest temperature
and run the appliance for approx. 8 minutes, checking that all functions are
working properly and the unit is responding to the remote control operations.
4. Repeat this same process while in heating mode.
While in each of these modes, we recommend checking the following functions:
• Ensure that the outlet air temperature responds to the cooling and heating modes.
• Check that the water is draining properly from the drainage hose.
• Check that the louvres rotate properly.
• Allow the air conditioner to run in test mode for at least 30 minutes.
• After a successful test run, return the settings to normal and press the ON/OFF
button on the remote to turn off the unit.
• Advise the user to carefully read this manual before using the air conditioner.
Demonstrate how to use the air conditioner, including necessary knowledge for
service and maintenance, as well as reminders for storing accessories.
Note: If the ambient temperature exceeds the range mentioned in the operation
instructions and the unit cannot run in COOLING or HEATING mode, lift the front
panel and refer to the emergency button operation to activate COOLING and
HEATING mode.
Installation (Cont.)