Euromatic EUR-26SPLIT - Important Safety Instructions

3
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | tempo.org/support
Important Safety Instructions
FOR THE INSTALLER
• Read this guide before installing and using the appliance.
• Compliance: Install the appliance in accordance with all applicable regulations.
• No children’s access: During installation of the indoor and outdoor units,
do not allow children access to the working area.
• Do NOT install the unit:
• In environments where the air could contain gas, oil or sulphur.
• Near sources of heat.
• At a distance of less than 50cm from flammable substances (e.g. alcohol or
other flammable liquids or gases) and pressurised containers (e.g. spray cans).
• Ventilation: If the appliance is used in areas without the possibility of
ventilation, precautions must be taken to prevent any leaks of refrigerant
gas from remaining in the environment and creating a fire danger.
• Outdoor unit: Make sure that the base of the outdoor unit is firmly fixed.
• Disconnect power circuits: Before accessing the terminals, all the power
circuits must be disconnected from the power supply.
• Refrigerant system: Check that air cannot enter the refrigerant system and
check for refrigerant leaks when moving the air conditioner.
• Voltage: Ensure that the mains voltage corresponds to that stamped on the
rating plate. Keep the switch or power plug clean.
• Socket: Check and ensure that the socket is suitable for the plug.
• Fuse ratings: The ratings of the fuse installed in the built-in control unit are
T 5A / 250V.
• Overload protection: The user must protect the indoor unit with a fuse of
suitable capacity for the maximum input current or with another overload
protection device.
• Packaging materials: The packaging materials are recyclable and should
be disposed of responsibly for recycling. This air conditioner contains a
flammable refrigerant, which must be removed before disposal. Contact
your municipal authorities for any codes or regulations concerning the
disposal of such materials.
PROTECT YOUR WARRANTY
These installation instructions for the Spilt System Air Conditioner
are for use by an appropriately qualified, licensed installer. The
appliance must be installed in accordance with all applicable
regulations. Do not try to install the appliance on your own; doing so
will expose you to danger and void the warranty.