EUTECH INSTRUMENTS COND 6 PLUS - 2 Getting Started; Description of Keypad Functions

Instruction Manual COND 6+, TDS 6+, SALT 6+
-2-
2. GETTING STARTED
2.1 Description of Keypad Functions
Your meter has 6 keys on its splash-proof keypad. Some
buttons have multiple functions depending on the mode of
operation.
ON/OFF Powers meter on and off. Meter starts up in the
measurement mode that you last switched off
from.
CAL Enters into calibration mode. Pressing while in
calibration mode will abort calibration without
confirming value.
MODE Selects desired measurement mode. When pressed simultaneously with
ON/OFF, it will take you into the SETUP mode. See ADVANCED SETUP
section for more information.
HOLD Freezes measured reading. Press again to resume live reading.
ENTER Confirms calibration value in calibration mode and confirm selections in
SETUP mode.
 Increment values during calibration mode or scroll through SETUP.
Activates manual ranging function during conductivity / TDS measurement.
 Decrement values during calibration mode.