Evco S.p.A. EVF815 | Installer manual ver. 1.1 | Code 144F815E114
page 12 of 58
3.3 User interface installation
Rear of panel, with biadhesive tape.
3.4 Control module installation
On flat surface, with spacers.
3.5 Installation warnings
- make sure that the device work conditions (temperature of use, humidity, etc.) lie within the limits indicated;
see chapter 14 "TECHNICAL DATA"
- do not install the device near to any heat sources (heating elements, hot air ducts etc.), equipment containing
powerful magnets (large diffusers, etc), areas affected by direct sunlight, rain, humidity, excessive dust,
mechanical vibrations or shocks.
- any metal parts in proximity of the control module must be at a distance such that they do not compromise the
safety distances.
- in compliance with Safety Standards, the device must be installed correctly and in a way to protect against any
contact with electric parts; all parts that ensure protection must be fixed in a way that they cannot be removed
without the use of tools.
To Next Page
Loading...
