Evenflo Gold SECUREMAX - Page 26

50 51
Close the Fit-loc belt tightener by
pushing down with your two thumbs
next to the indicator window. Keep
pushing down until it locks into place
and you see GREEN in the indicator
window on the base.
CHECK to make sure base is secure by
holding both sides of the base near the
LATCH strap and moving it from side
to side and front and back. The LATCH
belt should not loosen and the base
should not move easily. The base should
not move more than 2.5 cm (1 in.)
from side to side or front to back.
CHECK the recline indicator to make
sure the base is correctly reclined. If it is
not correctly reclined, remove LATCH
connectors, unlock the belt tightener
and adjust the foot on the base then
re-install base. CHECK that the base is
correctly reclined. Refer to pages 66-70
for Adjusting the Recline.
8
4
5
9
4
5
4
5
4
5
CLICK!
6
7
Push the LATCH connectors
onto the vehicle lower anchor
points on both sides of the base
until you hear them CLICK onto
the anchor points.
CHECK to make sure they are
securely attached by pulling on
them.
Pull the LATCH adjustment strap
while pushing base tight against
the seat. The LATCH strap will
slide out from under the LATCH
storage tab. If not, then pull out
manually. Continue to pull on
the adjustment strap to remove
all the slack from the LATCH
strap and to get the base snug
against the vehicle seat.
Lay the free end of the belt across
the belt path so it will be under
the Fit-loc belt tightener after it
has been closed.
10
11
CLICK!
LATCH
storage
tab
CLICK!
Installing the Base with the Lower Anchor
Connector Assembly (cont.)
Installing the Base with the Lower Anchor
Connector Assembly (cont.)