Evenflo Discovery 5 - Changing the Harness Position

30 31
Push the harness
anchor A located
on the back of the
child restraint
through the slot to
the front of the
seat shell. Repeat
this procedure on
both sides.
As your child grows, you will need to change the harness
strap position so that the harness straps are routed through
the slots closest to the child’s shoulders.The shoulder harness
straps should
ALWAYS be as close as possible to, but NEVER
above, the child’s shoulders.
Pull the harness
strap and anchor A
to the front of the
seat shell. Repeat
this procedure on
the opposite side.
Pull the harness strap from the back of the carrier while
pushing the chest clip
B, buckle tongue, harness
anchor and harness strap through to the back.
Ô
Choose the appropri-
ate slots for the new
harness position.
Push the harness
anchor
A, buckle
tongue, and harness
strap and chest clip
through to the front
of the child restraint. Repeat for the other harness strap.
Note: Harness strap should start at or below the child’s
shoulders.
Changing the Harness Position
6
1
2
5
3
Pull the harness
anchor A, harness
strap, buckle tongue,
and chest clip to the
front of the child
restraint.
Push the harness
anchor A through the
pad to the bottom of
the child restraint.
Pull the harness anchor A through the bottom of the
child restraint, and clip into place. Repeat on the
opposite side.
7
A
B
A
A
A
A
A
4