Evenflo EveryFit - Page 57

Booster
4. Lift up headrest pad.
Disconnect hook-and-
loop connectors on seat
pad.
Push the shoulder straps
behind the headrest
pad.
5. Pull harness straps,
chest clip, and buckle
tongues through the
forward-facing belt
guides. Snap the two
halves of the chest clip
together behind the
seat.
NOTE: Raise headrest
to desired height before
connecting chest clip.
6. Replace headrest pad.
7. Adjust booster seat to
the upright position.
High-Back Booster
Mode is complete.
PLACE
AT
ARMPIT
Convert from High-Back Booster to Harness Mode
• Disconnect chest clip from back of seat.
• Lift up headrest and pull shoulder straps through
forward-facing belt guides.
• Remove crotch buckle from slot at rear of seat base
and replace into proper crotch buckle slot (p. 67).
Replace seat back (p. 60).
• Raise headrest to desired height.
Converting Seat into High-Back Booster
57
Using Your Booster Seat in High-Back
Mode
PLACE
AT
ARMPIT