Evenflo EveryFit - Rear-Facing Installation Checklist

Rear-facing
37
1. Secure child restraint to the vehicle seat.
Child restraint is in one of the three rear-facing
recline positions, so that the level line is
parallel to the ground (pg. 28).
Towel rolled up and placed beneath the base, if
necessary, so that the level line is parallel to
the ground (pg. 32).
Install with Lower Anchor Connector (UAS)
Assembly (pg. 27) or vehicle seat belt (pg. 33).
To properly secure this child restraint it MUST
NOT move more than 2.5 cm (1 in.) from side to
side or front to back at the rear-facing belt path
(pgs. 32, 35, and 36).
Shoulder belt is routed through rear-facing lock-
off when installing with lap/shoulder belt. It is
recommended to lock retractor in addition to
using the lock-off, if vehicle permits (pg. 36).
Cupholders MUST be installed (pg. 22).
2. Set the child in the child restraint.
Top of head is at least 2.5 cm (1 in.) or more
below the top of headrest
Install Body Pillow if necessary (pg. 23).
The child’s back and bottom are flat against the
back and bottom surfaces of the child restraint.
Harness straps MUST be at or just below shoulder
height (pg. 26).
3. Fasten the buckle.
Buckle tongues are fully engaged (pg. 69).
4. Make necessary adjustments.
Crotch buckle MUST be in inner slot (pg. 67).
Harness straps MUST be snug against the child’s
shoulders, with no slack (pg. 69).
5. Position and connect chest clip.
Chest clip MUST be at armpit level (pg. 69).
Rear-facing Installation Checklist