Evenflo EveryFit - Rear-Facing Installation with Vehicle Seat Belts

To Next Page

To Previous Page

Rear-facing

IMPORTANT:

• Before installing this child restraint rear-facing with

the vehicle seat belt, you MUST move the Lower

Anchor Connector Assembly (UAS) to the forward-

facing belt path so that it does not interfere with

the vehicle seat belt. Refer to pg. 39 for instructions on

moving the Lower Anchor Connector Assembly (UAS)

to the forward-facing belt path.

• Check your vehicle owner’s manual to determine how

to lock your seat belt for child restraint installation. If

vehicle permits, the retractor must be locked.

• DO NOT use the Tether Strap when the child restraint

is in the rear-facing position. Store tether (pg. 71).

1. Make sure vehicle is on level ground.

2. Place child restraint rear-facing on approved vehicle

seat. Always make sure the bottom of the child

restraint sits ﬂat on the vehicle seat.

3. Reroute the lower

anchor connector

strap through the

forward-facing

belt path (pg. 39).

Store the lower

anchor connector

(UAS) as shown.

4. Lift up on the

recline handle

as shown and

adjust the seat to

one of the three

rear-facing recline

positions, so

that the level

line is parallel

to the ground.

Shoulder

straps must

be at or just

below child’s

shoulders

1,8 - 18,1 kg (4 - 40 lbs)

43 - 102 cm (17 - 40 in)

MUST be level with

ground with Rear Facing

installations

REAR FACING LINE

Top of head

MUST be 2.5 cm

(1 in.) or more

below top of

headrest or shell

Chest clip

25808432 8/19

Lap Shoulder Belt

LATCH / UAS

Lap Belt

Route shoulder belt

only through lock off.

See user manual for

additional information.

LOCK OFF

REAR FACING

BELT PATH