13
1. Secure child restraint to the vehicle seat.
•Recline Stand is flipped to the Upright position
(page 29).
•Install with vehicle seat belt (page 20) or LATCH
system (page 23).
•Install locking clip, if necessary (page 30).
2. Set the child in the child restraint.
Tops of the child’s ears are at or below the child
restraint seat back.
3. Make necessary adjustments.
•Crotch strap is snug against the child (page 33).
•Harness straps MUST be on the child’s shoulders
and snug with no more than two-fingers width
of space between the child and the harness strap
(page 32).
4. Fasten the buckle. Refer to page 32.
5. Position and connect chest clip.
Chest clip/harness tie MUST be at armpit level
(page 32).
6. Check your work.
•Recline Stand is flipped to the Upright position
(page 29).
•The child restraint DOES NOT move more than
25 mm (1 inch) forward or side-to-side (pages 21
and 25).
•The child’s back and bottom are flat against the
back and bottom surfaces of the child restraint.
•Shoulder harness straps MUST start at or above
shoulder height, using the strap slots closest to
your child’s shoulders (page 27).
•Buckle tongues are fully engaged.
WARNING
If your child weighs more than 22.6 kg (50 lbs) or their
shoulders are above the highest harness level, you MUST
discontinue use or the child restraint will not protect your
child.
To Next Page
Loading...
