32
Place baby in the child restraint. The baby’s back and
bottom should be flat against the restraint. If there
is a gap, the baby will not be comfortable.
Securing Your Child
1
Bring each harness strap
over the child’s shoulders.
Insert the buckle tongues A
into the buckle.
Pull up on the harness strap
to check that the buckle
tongues are fastened.
A
B
2
The harness straps must be snug against the child.
A snug strap should not allow any slack. It lies in a
relatively straight line without sagging. It does not
press on the child’s flesh or push the child’s body into
an unnatural position. Check the harness straps near
the shoulders for slack and adjust as needed.
Fasten the chest clip
B
by snapping the two
halves together, as
shown.
Slide chest clip to armpit
level.
Ö
Ö
Ö
To Next Page
Loading...
