Evenflo Titan - Installing Tether Strap

22
Attach tether hook E
to the tether anchor
bracket F in your
automobile.
Pull the end of the
strap G to tighten.
Remove all slack in
the strap.
•Toavoidastrangulationhazard,youMUST tightly
roll or fold excess tether strap and secure with the
strap/rubber band.
•Attachthetetherhooktothestorageclipwhennot
in use. This will keep an unused tether from hitting
someone during a crash.
WARNING
After adjusting the top tether strap, you may have
excess strap; DO NOT cut it off. If you do, it may not
be long enough to use in another vehicle. Instead,
tightly roll up the excess tether strap and place the
rubber band around the bundle.
Note: Refer to your vehicle owner’s manual for the
location of the tether anchor bracket in your vehicle.
Older vehicles may not come equipped with anchor
bracket hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors that
are not addressed by the vehicle owner’s manual or
answered by an authorized dealer/vehicle manufac-
turer, call Evenflo’s ParentLink.
E
F
G
6
WARNING
•Failuretofollowtheseinstructionscouldresultin
serious injury to your child or other vehicle occupants.
•Thetetherstrapisforforward-facing use only.