Restore Cone Offsets!
Reset cone offsets to factory settings. Default Cone Offset = 0 for all cones. To reset: Press
“3-Reset Cone Offs” and press “RESTORE”.!
Restore Glass!
Restore the Glass firing setting back to factory. Once “RESTORE” is pressed, any changes!
made to the Glass profiles will be restored back to factory and cannot be undone.!
Restore Factory Default!
Restore the entire controller to the default factory settings. Take caution using this menu
option as it will reset any customization.!
Factory Protected
Factory configuration is used by the kiln manufacturer to set kiln specific parameters for the
controller such as thermocouple type, top temperature, and board temperature. For more
information, see the technical manual online. Contact the kiln manufacturer before making any
changes that might damage the kiln.!
To Next Page
Loading...
