Cone Menu
Allows the user to enable or disable the cone fire programming menu. When disabled, the
Bisc and Glaze programs will be removed under “Fire”.!
Glass Menu
Allows the user to enable or disable the glass programming menu. When disabled, the
glass programs will be removed under “Fire”.!
PMC Menu
Allows the user to enable or disable the precious metal clay programming menu. When
disabled, the glass programs will be removed under “Fire”.!
Heat Treat Menu
Allows the user to enable or disable the heat treat programming menu. When disabled,
the glass programs will be removed under “Fire”.!
Temperature F/C!
Choose which temperature scale to use with your kiln, Fahrenheit or Celsius. To change the
temperature scale, press “Temperature F/C”, press the desired temperature scale, either
“Fahrenheit” or “Celsius”, and press “Save”.!
Cost Setup!
This menu option allows you to enter a cost per hour for your energy usage. By entering this
information you can see the estimated cost for a firing.!
Start Code!
The Start Code is entered to start a firing. Enter any 4 number combination and press
“Save”. Default = 1. This will be entered anytime the kiln is fired.!
WiFi!
To set up Wi-Fi for the Spark, press “WiFi” and the controller will scan for nearby networks.
Select your desired network and enter the password (if required) and press “Save”.!
Calibrate Touch!
Used to re-calibrate the touch screen if buttons aren’t working properly. Press the “Calibrate
Touch” button and follow the onscreen instruction to re-calibrate.!
Software Reset!
Use this option if you need to restart your controller for any reason.!
Restore Presets
Restore all preset programs and offsets to factory settings.!
To Next Page
Loading...
