Evenheat RampMaster II User Manual

RampMaster II Operating Manual
RMII – Aug. 2015
Page 21 of 26
Use your Smart-phone to scan this QR code to watch RampMaster II how-to Programming Videos!
OTHER
While at the Idle Position (IdLE) While Running a Program At Any Other Position
Allows you to Access the Settings of Reset, Pre-
heat, ID, 16 Segments, Cone Offset, Change
Temperature Scale, Error Code Enable/Disable,
Thermocouple Offset, Percent 4, Board
Temperature and Reset.
Allows you to change the Percent 4 value.
Percent 4 Feature unavailable
on ceramic kiln models.
No Function
13 HR.
While at the Idle Position (IdLE) While Running a Program At Any Other Position
Initiates the Cone Fire Mode Programming
Process and Selects the 13 hour Preset Cone Fire
Mode Program.
No Function No Function
10 HR.
While at the Idle Position (IdLE) While Running a Program At Any Other Position
Initiates the Cone Fire Mode Programming
Process and Selects the 10 hour Preset Cone Fire
Mode Program.
No Function No Function
7 HR.
While at the Idle Position (IdLE) While Running a Program At Any Other Position
Initiates the Cone Fire Mode Programming
Process and Selects the 7 hour Preset Cone Fire
Mode Program.
No Function No Function
4 HR.
While at the Idle Position (IdLE) While Running a Program At Any Other Position
Initiates the Cone Fire Mode Programming
Process and Selects the 4 hour Preset Cone Fire
Mode Program.
No Function No Function

Evenheat RampMaster II Specifications

General

Brand	Evenheat
Model	RampMaster II
Category	Controller
Language	English