OPERATING INSTRUCTIONS
Full-automatic programming:
This function is used to cook after a certain period of time with a certain duration. Place the food to be cooked into
the oven. The oven is adjusted to the desired cooking function. The oven temperature is adjusted to the desired
temperature depending on the food to be cooked.
1. Press " " button until you see " Dur " on the timer screen.
2. Use " + " and " - " button to adjust cooking period for the food you wish to cook.
3. Press “ " button to confirm, the days’ time will appear on the screen and the symbol " A " will begin to
continuously light on the screen.
4. Keep pressing on " " button until you see " End " on the timer screen. When you see " End “ on the timer
screen, press " + " and " - " button to adjust finishing time
5. Press " " button to confirm, the days’ time will appear on the screen and the symbol " A " will begin to
continuously light on the screen. The symbol " " disappears until the time cooking starts.
6. You can set a time which can be up 23.59 hours after the time obtained by adding the cooking period to the
days’ time.
7. The oven will start operating at the time calculated by deducting the cooking period from the set finishing
time and will stop at the set finishing time. The timer will give an audible warning and the symbol "A" will
begin to flash.
8. After bringing the cooking function and oven temperature knob to" 0 "position, press any button for less
than 3 seconds, it will stop the audible warning.
Pressing " " for more than 3 seconds sets the oven to Manual mode again to use the oven.
Please note:
Once setting full-automatic mode, the time cannot be changed
To change the time you have to cancel automatic program and enter into corresponding mode.
If you need to reset automatic mode, you need to cancel out of the current mode, and set the automatic mode
according to the above steps again.
Specification:
1. When setting the date of each function, long press on " + " or " - " for more than 3 seconds, the date will
progressively and rapidly increase or decrease.
2. When setting each of the time function, if there is none operation for 5 minutes then it will return to manual
mode.
3. When setting each of the time function, pressing on " " for more than 3 seconds can cancel current
setting and enter manual mode.
4. During time function setting, press on " + " and " " for more than 3 seconds, a beep sounds. It will cancel
the current time function setting and enter standby mode.
5. We suggest that you run the oven elements for 15 minutes at 200 degrees to burn off any residue from their
surfaces.
To Next Page
Loading...
