63
Electrical System
This pump will run as needed whenever the water
in the bilge accumulates high enough to cause the
switch to activate and turn off when the water is
removed.
Notice:
The bilge pumps will start automatically when
there is sufcient water in the bilge to acti-
vate the automatic switch. Each automatic
switch is protected by a fuse located near
the battery switches and is always supplied
current when the batteries are connected.
Horn
Activates the boat air horn located on the hardtop.
Baitwell Pump
Activates the pump that supplies seawater to the
baitwell.
Baitwell Recirc
Activates the pump that recirculates the water in
the baitwell.
Baitwell Light
Activates the light in the baitwell.
ACC
Reserved for additional DC accessories installed
by you or your Everglades dealer.
Livewell Pump
Activates the pump that supplies seawater to the
livewell.
Livewell Recirc
Activates the pump that recirculates the water in
the livewell.
Livewell Light
Activates the light in the livewell.
ACC
Reserved for additional DC accessories installed
by you or your Everglades dealer.
Fresh Water
Activates the pump that supplies water pressure
for the fresh water system. The pump is the pres-
sure demand type. A pressure switch automati-
cally controls the water pump when the system
is activated and properly primed.
Raw Water
Activates the raw water system pump that supplies
the raw washdown hose connector in the cockpit.
The pump is the pressure demand type. A pres-
sure switch automatically controls the water pump
when the system is activated and properly primed.
Windlass
A three position momentary switch that controls
the windlass which is mounted in the compart-
ment above the rope locker. The middle position
is OFF. Press and hold the switch UP to raise the
anchor. Press and hold the switch DOWN to lower
the anchor. The switch automatically returns to
the Middle (OFF) position when it is released.
The windlass switch circuit is protected by a circuit
breaker in the head compartment breaker panel.
The primary windlass circuit is protected by a cir-
cuit breaker of the type and rating recommended
by the windlass manufacturer that is located near
the battery switches.
Battery Parallel
Activates the circuit that connects the port and
starboard engine starting batteries in parallel for
extra battery power while starting those engines.
When the switch is turned on, relays are engaged
that connect the engine starting batteries, when
the switch is turned off, the relay is deactivated
and the batteries are isolated.
Helm Switch Panel
To Next Page
Loading...
