94
Exterior Equipment
Helm Seat Bolsters In Leaning Post Position
Helm Seat Bolsters In Seat Position
Bait Station Sink & Baitwell
Cockpit Rod Racks
Rod Racks
There are recessed rod storage racks located
below the gunnel on each side of the cockpit.
They are equipped with stretch cords to secure
the rods to the racks. Always make sure the rods
are properly secured in the storage racks with the
rod tips forward.
Bait Station and Baitwell
A bait prep station equipped with a baitwell, accom-
modation for 2 Yeti Hopper coolers, tackle storage
and a recess for a re extinguisher is built into the
rear of the helm seat base. The baitwell is drained
by gravity to a thru-hull tting in the hull side.
Grab rails and cup holders are built into the top of
the station. There is a tackle locker on each side
with removable trays. The “push to close” latches
on the tackle locker doors latch automatically and
are lockable.
Helm Seats
The helm and passenger seats are equipped with
a ip up bolster to provide more room between
the seats and the helm. The bolsters convert the
seats to a leaning post style seat with a backrest,
allowing the operator and passenger to sit or stand
at the helm. To convert each seat to a leaning
post, lift the front of the seat cushion to raise the
bolster and push it back above the seat cushion.
Arm rests on each side provide a more comfortable
driving position. A molded in footrest on the rear
of the console makes the helm more comfortable
when the bolsters are set to the seat position.
To Next Page
Loading...