Everlast Hurricane 220 MTS-C

Need help?

Do you have a question about the Everlast Hurricane 220 MTS-C and is the answer not in the manual?

Summary

Safety and General Information

Safety Warnings, Dangers, Cautions and Instructions

Comprehensive safety guidelines, warnings, and instructions for operating the equipment.

Important Information: Operating this unit with a generator or other off-grid service.

Guidelines for operating the unit with generators, including power quality requirements and warnings.

Specifications and Component Identification

Specifications

Detailed technical specifications for the welding and cutting unit.

BREAKER SIZING AND WIRING REQUIREMENTS

Requirements for electrical breaker sizing and wiring installation of the unit.

Front Panel View

Identification and explanation of components on the front panel of the unit.

Rear Panel View

Identification and explanation of components on the rear panel of the unit.

IPT 40 Innotec Plasma Torch

Identification and parts list for the IPT 40 plasma torch.

Setup and Operation

Setup Guide

General guide for unpacking, inspecting, and setting up the welding unit.

CONNECT YOUR UNIT TO POWER.

Instructions for connecting the unit to the appropriate power source.

INSTALL THE AIR REGULATOR AND AIR COMPRESSOR.

Steps for installing the air regulator and connecting an air compressor.

CONNECT YOUR UNIT TO THE CORRECT SHIELDING GAS.

Guidance on selecting and connecting the appropriate shielding gas.

SELECT THE CORRECT MIG AND FLUX-CORED POLARITY.

Instructions for setting the correct polarity for MIG and Flux-Cored welding.

CHECK AND CHANGE YOUR DRIVE ROLL.

Procedure for checking and changing the wire feed drive rolls.

Control Panel Layout

Identification and explanation of controls and indicators on the unit's control panel.

GENERAL INFORMATION ON SETUP AND USE.

General guidance on setup, navigation, and parameter adjustment for operation.

Setting the Unit Up in The PowerSet Mode

How to use the PowerSet mode for automated welding parameter setup.

Process Functions and Techniques

Setting the Unit Up for Welding;Cutting Manually

Detailed guide for manual setup of welding and cutting processes.

Using The Trigger;Torch Switch Remote Functions

Explanation of 2T/4T trigger functions and remote operation.

Explanation of MIG Functions and Terms

Detailed explanation of MIG welding functions and terminology.

Explanation of TIG Functions and Terms

Detailed explanation of TIG welding functions and terminology.

SELECT THE PROPER TUNGSTEN TYPE.

Guidance on selecting the correct tungsten electrode for TIG welding.

SELECT THE PROPER TUNGSTEN SIZE AND START AMPS.

Guidance on selecting proper tungsten size and start amperage for TIG.

Explanation of Stick Functions and Terms

Detailed explanation of Stick welding functions and terminology.

Plasma Cutter Function Important Information and Warnings:

Critical information and warnings specific to plasma cutting operation.

Explanation of Plasma Cutting Functions and Terms

Detailed explanation of plasma cutting functions and terminology.

Additional Plasma Torch Information

Additional details and troubleshooting for plasma torches.

Troubleshooting

Error Codes

List of error codes and their meanings for diagnosing unit issues.

Common MIG;Flux Cored Issues

Common problems and solutions for MIG and Flux-Cored welding.

Common TIG Issues

Common problems and solutions for TIG welding.

Common Plasma Cutting Issues

Common problems and solutions for plasma cutting.