Application Note 65
Quartz Routing Switcher Remote Control Protocol
Page - 16 Revision 1.4
.#46,{xx}(cr) Get general error number for address.
.#47,{xx},{nn}(cr) Get specific error number occurrences for device.
.#48,{xx}(cr) Clears error count for device.
.#49,{xx}(cr) Get general report number for address (can then get details).
.#50,{xx}(cr) Get type and version numbers of Q-link device from master – uses stored
information retrieved from polling (or slave, but only own data).
.#51,{xx}(cr) Force master to enquire type and version numbers of Q-link device (uses
fetched data).
.#56(cr) Reserved (halt panel updates).
.#67(cr) Reserved (restart panel updates).
.#78(cr) Reserved (enable extended protocol).
.#80,75(cr) Jump to boot loader.
.#81(cr) Boot loader command, DO NOT USE.
3.14. VIDEO STATUS DISPLAY
These commands only work when the status display is operating in stand alone mode.
.VP-(cr) Display page decrement.
.VP+(cr) Display page increment.
.VP{xx}(cr) Display page xx (01, 02, etc)
3.15. ENGINEERING COMMANDS
All the values in brackets {xx} are two digit hexadecimal numbers.
.&LOCALTCPIP,192.0.2.100(cr) Set TCP/IP address of the controller you are connected to.
.&REMOTETCPIP,192.0.2.101(cr) Set TCP/IP address of the other controller in a dual
redundant configuration.
.&TCPGATE,192.0.2.52(cr) Sets TCP/IP address of the network gateway.
.&TCPMASK,192.0.2.52(cr) Sets TCP/IP address mask.
.&LOCALTCPIP(cr) Sending any of the above four commands as shown
returns the address of the device in the same format as
the set commands.
To Next Page
Loading...
