To Next PageTo Next Page
Need help?Do you have a question about the evertz XRF6 and is the answer not in the manual?
Guide on how to navigate and understand the manual's structure and content.
Details on the rear panel layout, physical mounting, and cooling system of the router.
Procedures for connecting power, including details on power supply indicators.
Overview of serial and Ethernet ports for controlling and communicating with the router.
Step-by-step guide for installing and removing circuit cards from the router frame.
Steps to connect a PC to the frame controller for initial configuration via serial port.
Menus for configuring network settings and the router's crosspoint matrix and input/output settings.
Settings for SNMP, serial control, and viewing card status and engineering options.
How to use the card-edge interface for input card configuration and status.
Information on the output card edge interface, noting it is currently not supported.
Explanation of LEDs on power supply and frame controller modules for status and faults.
Details on LEDs for input/output cards, indicating board status and RF signal levels.
Overview of the X-NCP2 panel for controlling the XRF6 router and its features.
Introduction to VistaLINK® for remote monitoring, configuration, and alarm management.
Detailed technical specifications covering system, RF, communication, electrical, and physical aspects.
Guidelines for qualified personnel on servicing the router, including fuse and power supply replacement.
Step-by-step instructions for upgrading firmware using Evertz VistaLINK® Pro software.
Procedure for upgrading firmware using a PC and serial connection via RS232.
Guide on how to navigate and understand the manual's structure and content.
Details on the rear panel layout, physical mounting, and cooling system of the router.
Procedures for connecting power, including details on power supply indicators.
Overview of serial and Ethernet ports for controlling and communicating with the router.
Step-by-step guide for installing and removing circuit cards from the router frame.
Steps to connect a PC to the frame controller for initial configuration via serial port.
Menus for configuring network settings and the router's crosspoint matrix and input/output settings.
Settings for SNMP, serial control, and viewing card status and engineering options.
How to use the card-edge interface for input card configuration and status.
Information on the output card edge interface, noting it is currently not supported.
Explanation of LEDs on power supply and frame controller modules for status and faults.
Details on LEDs for input/output cards, indicating board status and RF signal levels.
Overview of the X-NCP2 panel for controlling the XRF6 router and its features.
Introduction to VistaLINK® for remote monitoring, configuration, and alarm management.
Detailed technical specifications covering system, RF, communication, electrical, and physical aspects.
Guidelines for qualified personnel on servicing the router, including fuse and power supply replacement.
Step-by-step instructions for upgrading firmware using Evertz VistaLINK® Pro software.
Procedure for upgrading firmware using a PC and serial connection via RS232.
General| Brand | evertz |
|---|---|
| Model | XRF6 |
| Category | Network Hardware |
| Language | English |
