evertz XRF6 - SNMP, Serial Control, and Card Status

XRF6 RF Router Manual
CONFIGURATION Revision 1.0 Page 3-7
------------------------------------------------
| Input Configuration |
| (X6RF-FC v1.00 b166) |
------------------------------------------------
output input
------ -----
1 <--- 2
2 <--- 3
3 <--- 3
4 <--- 4
5 <--- 5
6 <--- 6
7 <--- 7
8 <--- 11
9 <--- 9
10 <--- 7
11 <--- 11
12 <--- 12
13 <--- 13
14 <--- 2
15 <--- 15
16 <--- 12
------------------------------------------------------------
(1) Set crosspoint
(X) Exit
>
3.4. SNMP SETUP
The SNMP Setup menu is used to set the SNMP trap IP address used for alarm reporting over SNMP for
VistaLINK
®
or third party M&C systems. It also displays the current IP address table stored in the frame
controller flash memory.
------------------------------------------------
| SNMP Setup |
| (X6RF-FC v1.00 b166) |
------------------------------------------------
----------------------------------
Trap Destination 1: 192.168.8.3
----------------------------------
(1) Set Trap IP Address
(2) Remove Trap IP Address
(3) Retrieve Trap IP Addresses from flash
(S) Save and Exit
(X) Exit
>

All changes made within this menu must be saved prior to exiting this menu level
by selecting the “(S) Save and Exit” command. Failure to do so will result in the
changes not taking effect.