XRF6 RF Router Manual
INSTALLATION Revision 1.0 Page 2-3
2.4. POWER
2.4.1. Connecting the Power
Figure 2-2: Connecting the Power to the XRF6-FR
The XRF6-FR frame comes standard with one auto-ranging power supply (XRF6PS) that automatically
senses the input voltage over the range of 100 to 240 VAC. An additional power supply (XRF6PS) can be
ordered to provide fully redundant powering of the frame. When only one power supply is fitted, the frame
will be fitted with a XRF6PS-FM fan module to ensure the thermal integrity of the frame cooling. In a
frame that contains a redundant power supply module, each power supply may be powered from a
different AC mains source, allowing complete AC supply redundancy.
Power should be applied by connecting a 3-wire grounding type power supply cord to the power entry
module on the rear panel of each power supply. For use in North America, the power cord should be
minimum 18 AWG wire size; type SVT marked VW-1, maximum 2.5 m in length. For use outside North
America use a power cord approved for the country of use with a minimum 1.00 mm
2
wire size.
The power entry modules contain a standard IEC power inlet connector, two 5 x 20 mm fuse holders and
an EMI line filter.
To Next Page
Loading...
