evertz XRF6 - Show Card Status; Engineering; Debug

XRF6 RF Router Manual
CONFIGURATION Revision 1.0 Page 3-9
------------------------------------------------
| Serial Control Port Configuration |
| (X6RF-FC v1.00 b166) |
------------------------------------------------
------------------------------------------------
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 2
Standard: RS 232
Protocol: Evertz Router Control
------------------------------------------------
(1) Set baud rate
(2) Set number of data bits
(3) Set parity
(4) Set number of stop bits
(5) Set standard
(6) Set protocol
(X) Exit
>
At this time, the only supported protocol for the serial port is the “Evertz Router Control” protocol.
3.6. SHOW CARD STATUS
This command shows the current card status of all the input and output cards within the frame. It can be
used to verify that all cards within a frame are recognized by the frame controller. It will also indicate if
there are any current problems communicating with each card. An example of a card status display for a
frame with one input card and one output card is shown below.
Slot Number Card Type Start End Configured Active Problem
----------- --------- ----- ----- ---------- ------ -------
1 I16LB 1 16 y y
2 I16LB 17 32 n n
3 O16LB 1 16 y y
4 O16LB 17 32 n n
5 O16LB 33 48 n n
6 O16LB 49 64 n n
7 I16LB 33 48 n n
8 I16LB 49 64 n n
3.7. ENGINEERING / DEBUG
This menu contains several menu commands that are intended for use only by Evertz engineering staff.