Application Note 65
Quartz Routing Switcher Remote Control Protocol
Revision 1.4
REVISION HISTORY
REVISION DESCRIPTION DATE
1.2.5 Updates throughout March 2006
1.2.6 Updates throughout July 2006
1.2.7 Changes to the Queue command. October 2009
Change the .QS command changed to .QF command.
Change the loading of salvo crosspoints from
the .SVxx,yy command to .QSxx,yy command.
This change is not backwards compatible.
1.2.8 Changes to Queue commands to remove reset October 2009
and destroy all if 0 specified.
Added fire at specified time command.
1.2.9 .QC{n}(cr) command reply changed from .QC{n}(cr) to .A(cr) January 2010
1.3 Added appendix A, supported commands June 2012
1.3.1 Added notes regarding obsolete commands, adjusted appendix June 2012
A regarding support of .L for certain routers
1.4 Added SC2000 information Nov 2012
Information contained in this manual is believed to be accurate and reliable. However, Evertz assumes no responsibility for the use thereof
nor for the rights of third parties, which may be affected in any way by the use thereof. Any representations in this document concerning
performance of Evertz products are for informational use only and are not warranties of future performance, either expressed or implied. The
only warranty offered by Evertz in relation to this product is the Evertz standard limited warranty, stated in the sales contract or order
confirmation form.
Although every attempt has been made to accurately describe the features, installation and operation of this product in this manual, no
warranty is granted nor liability assumed in relation to any errors or omissions unless specifically undertaken in the Evertz sales contract or
order confirmation. Information contained in this manual is periodically updated and changes will be incorporated into subsequent editions. If
you encounter an error, please notify Evertz Customer Service department. Evertz reserves the right, without notice or liability, to make
changes in equipment design or specifications.
To Next Page
Loading...
