R410A 60Hz EER 2.36 Series Service Manual
does not flicker.
Exit setting
Pressing the mode key and lock key at the same time can exit the address setting interface.
If there is no key pressing associated with address setting for more than 30 minutes, the remote controller will exit
the address setting interface.
Battery replacement
1
If the air conditioner is unable to receive the signal from the wire controller, or the LCD of wire controller is
blurred, it means that the battery is depleted and needs to be replaced.
2
Take off the back cover and remove the old batteries. When replacing batteries, please pay attention to the "+"
and "-" marking on the battery.
3
Install the back cover and set the current time.
When the wire controller is idle for a long time, the battery should be removed.
In general, the service life of a dry battery that meets the JIS or IECstandards can be up to 6-12
months, but if it exceeds the use time or not in conformity with above specifications, the dry battery
may leak and may even cause the wire controller operation to be invalid.
The recommended service life is marked on the battery, but the actual service life may be shorter.
To Previous Page