317
MANUAL STARTER
RECOIL STARTER INSTALLATION
15
RECOIL STARTER
INSTALLATION
Apply Nut Lock to the threads of starter ratchet
screws. Install washers and ratchet on flywheel.
Tighten screws to a torque of 120 to 144 in. lbs.
(13.5 to 16 N·m).
Place the starter assembly onto the outboard.
Install the starter housing retaining screws, wash-
ers, and lock washers. Be sure to place washers
between the starter housing and the flywheel
cover. Apply Ultra Lock to threads and tighten the
three starter housing screws to a torque of 120 to
144 in. lbs. (14 to 16 N·m).
Install clamp for oiling system wiring harness.
006654
1. Starter housing screws (3)
2. Clamp
002515
1
2
1
1
To Next Page
Loading...
