Evinrude E-TEC G2 Operator's Guide

12
Using Your Evinrude E-TEC G2 Outboard
Component Identification
200, 225, 250, 300 HP 74° V6
NOTE: Some engine safety labels are not shown on illustrations. For information on engine
safety labels, refer to Important On-Product Labels on page 10.
Item Description Item Description
1 Air Inlet 6 Water Intake Screens
2 Cover Fasteners (6) 7 Anodes
3 Tilt Support Lever 8 Rigging Center cable entry
4 Anode 9 Trailering Tilt Switch
5 Anode
(propeller shaft)
009041
1
2
2
2
4
9
8
6
7
7
6
5
3

Evinrude E-TEC G2 Specifications

General

Bore x Stroke	Varies by model
Full Throttle RPM Range	5400-6000 RPM
Alternator Output	133 Amps Total / 50 Net Dedicated
Lubrication	Multi-point targeted oiling
Cylinder Configuration	V6
Gear Ratio	1.85:1
Starting	Electric
Engine Type	2-stroke
Shaft Length	20", 25", 30"
Fuel Induction	Direct Fuel Injection (DFI)
Emissions	EPA 2013
Horsepower Range	150 - 300 HP
Fuel Type	87 Octane
Weight	505 - 635 lbs (varies by model)