Evinrude E10R4 User Manual

35
ENGINE OPERATION
6
If the choke solenoid fails to
operate (E and P type only)
①
Remove the top cowl.
②
Close the choke plate by finger.
③
Raise the Free accel lever a little.
④
Turn the main switch key to start
position.
⑤
Stop pushing the key when the en-
gine has started.
⑥
Return the choke plate to open po-
sition.
Choke
plate
(open position)
(closed
position)
War m the engine at low engine
speeds for about three minutes. This
allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
Be sure to check that cooling water is
coming out of the cooling water check
port during warm up.
If the engine is operated without water
discharging from the check port, the
engine may over heat.
!
CAUTION
Cooling
water
check port
Be sure to stop engine immediately
if cooling water check port is not
discharging water, and check if cooling
water intake is blocked. Operating
engine could lead to overheating
potentially leading to engine damage.
Consult an authorized dealer if the
cause cannot be found.
!
CAUTION
4. Warming up the engine
OM_E_10HP_body_111213.indd 35 11/12/13 13:23

Evinrude E10R4 Specifications

General

Brand	Evinrude
Model	E10R4
Category	Outboard Motor
Language	English